Back to articles
Articles
Volume: 27 | Article ID: art00089_2
Image
2D Thermal Analysis to Predict a Fuser Performance
Jun O Kim
Youngdae Ko
Sokwon Paik
  DOI :  10.2352/ISSN.2169-4451.2011.27.1.art00089_2  Published Online :  January 2011
Abstract

A simulation method to predict a fuser performance is presented. It is based on the 2D thermal analysis using Comsol software. The analysis model consists of a 2 roll-type IH fuser and paper with toner on it. A sequence of warm-up, print, ready, and warm-up again is simulated. The warm-up time to print, print power, ready temperature, ready power, and FCOT (first copy out time) are estimated. Based on the analysis results the TEC (typical electricity consumption) is estimated for the fuser. The estimated fuser performance is compared to the measured data from the fuser jig test.

Journal Title : NIP & Digital Fabrication Conference
Publisher Name : Society of Imaging Science and Technology
Publisher Location : 7003 Kilworth Lane, Springfield, VA 22151, USA
Subject Areas :
Views 13
Downloads 0
 DOI 10.2352/ISSN.2169-4451.2011.27.1.art00089_2
 articleview.views 13
 articleview.downloads 0
  Cite this article 

Jun O Kim, Youngdae Ko, Sokwon Paik, "2D Thermal Analysis to Predict a Fuser Performance"  in Proc. IS&T Int'l Conf. on Digital Printing Technologies and Digital Fabrication (NIP27),  2011,  pp 755 - 760,  https://doi.org/10.2352/ISSN.2169-4451.2011.27.1.art00089_2

 Copy citation
  Copyright statement 
Copyright © Society for Imaging Science and Technology 2011
72010410
NIP & Digital Fabrication Conference
nip digi fabric conf
2169-4451
Society of Imaging Science and Technology
7003 Kilworth Lane, Springfield, VA 22151, USA
2169-4451(20110101)2011:2L.755;1-
nip_v2011n2/splitsection89.xml
/ist/nipdf/2011/00002011/00000002/art00089
Articles
2D Thermal Analysis to Predict a Fuser Performance
KimJun O
KoYoungdae
PaikSokwon
01012011
2011
2
755
760
2011
A simulation method to predict a fuser performance is presented. It is based on the 2D thermal analysis using Comsol software. The analysis model consists of a 2 roll-type IH fuser and paper with toner on it. A sequence of warm-up, print, ready, and warm-up again is simulated. The warm-up time to print, print power, ready temperature, ready power, and FCOT (first copy out time) are estimated. Based on the analysis results the TEC (typical electricity consumption) is estimated for the fuser. The estimated fuser performance is compared to the measured data from the fuser jig test.