Back to articles
Articles
Volume: 18 | Article ID: art00048_2
Image
Standardization of The Blow-off Charge Measurement Procedure and Standard Developer
  DOI :  10.2352/ISSN.2169-4451.2002.18.1.art00048_2  Published OnlineJanuary 2002
Abstract

The Imaging Society of Japan (ISJ) Technical Committee part III meeting (The technical committee of toner-based material) standardized the blow-off toner charge measurement procedure, and released the standard twocomponent developer for the procedure. According to the standard procedure, the dispersion of the measured amount of toner charge (q/m) in the same two-component developer is minimized even when different operators measure the charge with different types of Faraday-cages. The obtained q/m according to the standardized procedure can be treated as a reproducible common value which can be obtained by everybody. The standard two-component developer can be used not only for calibrating Faraday-cages or blow-off measuring apparatuses, but also for carrying out quality control in the manufacturing of toner and carrier.

Subject Areas :
Views 10
Downloads 0
 articleview.views 10
 articleview.downloads 0
  Cite this article 

Toshihiko Oguchi, Masatoshi Kimura, Noboru Sawayama, Chiaki Suzuki, Yasusuke Takahashi, Manabu Takeuchi, Tatsuya Tada, Katsuyoshi Hoshino, "Standardization of The Blow-off Charge Measurement Procedure and Standard Developerin Proc. IS&T Int'l Conf. on Digital Printing Technologies (NIP18),  2002,  pp 631 - 631,  https://doi.org/10.2352/ISSN.2169-4451.2002.18.1.art00048_2

 Copy citation
  Copyright statement 
Copyright © Society for Imaging Science and Technology 2002
72010410
NIP & Digital Fabrication Conference
nip digi fabric conf
2169-4451
Society of Imaging Science and Technology
7003 Kilworth Lane, Springfield, VA 22151, USA